Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER › 2014.11–2016.05
RM2070E _56 Audio / Visual / Telematics _061931 AUDIO / VIDEO _0301719 RADIO RECEIVER A

AUDIO / VIDEO  RADIO RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55440D 9.REMOVE INSTRUMENT PANEL BOX ASSEMBLY

Hide 10.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 11.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET

a.
E306929

Remove the 4 bolts.


b.
E306930

Disengage the 5 claws and 2 guides.


c.

Disconnect each connector and remove the radio and display receiver assembly with bracket.


Hide 86842 12.REMOVE NO. 1 NAVIGATION WIRE (w/ Navigation System)

Hide 86101M 13.REMOVE ANTENNA CORD SUB-ASSEMBLY (w/ Navigation System)

Hide 86211J 14.REMOVE NO. 1 RADIO RECEIVER BRACKET

a.

w/o Navigation System:

i.
E300949

Remove the 3 screws and No. 1 radio receiver bracket.



b.

w/ Navigation System:

i.
E307304

Remove the 5 screws and No. 1 radio receiver bracket.



Hide 86212C 15.REMOVE NO. 2 RADIO RECEIVER BRACKET

a.

w/o Navigation System:

i.
E300950

Remove the 3 screws and No. 2 radio receiver bracket.



b.

w/ Navigation System:

i.
E307305

Remove the 5 screws and No. 2 radio receiver bracket.



Hide 86841 16.REMOVE NAVIGATION ECU (w/ Navigation System)

Hide 86140A 17.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY