1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
8.REMOVE INTEGRATION CONTROL AND PANEL
55440D
9.REMOVE INSTRUMENT PANEL BOX ASSEMBLY
10.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
11.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Remove the 4 bolts.
Disengage the 5 claws and 2 guides.
Disconnect each connector and remove the radio and display receiver assembly with bracket.
86842
12.REMOVE NO. 1 NAVIGATION WIRE (w/ Navigation System)
86101M
13.REMOVE ANTENNA CORD SUB-ASSEMBLY (w/ Navigation System)
86211J
14.REMOVE NO. 1 RADIO RECEIVER BRACKET
w/o Navigation System:
Remove the 3 screws and No. 1 radio receiver bracket.
w/ Navigation System:
Remove the 5 screws and No. 1 radio receiver bracket.
86212C
15.REMOVE NO. 2 RADIO RECEIVER BRACKET
w/o Navigation System:
Remove the 3 screws and No. 2 radio receiver bracket.
w/ Navigation System:
Remove the 5 screws and No. 2 radio receiver bracket.
86841
16.REMOVE NAVIGATION ECU (w/ Navigation System)
86140A
17.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY