86160B
1.INSTALL REAR SPEAKER ASSEMBLY
Using an air riveter or a hand riveter, install the rear speaker assembly with 3 new rivets.
| *1 | Riveter | *2 | Mandrel |
| *a | INCORRECT | *b | CORRECT |
Do not touch the cone part of the speaker.
Do not pry on the rivets with the riveter, as this will cause damage to the riveter and mandrel.
Confirm that the rivets are seated properly against the speaker.
Do not tilt the riveter when installing the rivets to the speaker.
Do not leave any clearance between the rivet heads and speaker.
Do not leave any clearance between the speaker and door. Firmly hold the 2 items together while installing the rivets.
Install the rivets in the order shown in the illustration.
Connect the connector.
86160Y
2.INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)
Install the rear No. 2 speaker assembly with the 2 screws.
Engage the clamp.
Securely engage the clamp.
67604
3.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
74262
4.INSTALL REAR DOOR ARMREST COVER
5.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
69284D
6.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG