Home › Audio / Visual / Telematics › AUDIO / VIDEO › STEREO JACK ADAPTER ASSEMBLY › 2013.08–2014.11
RM2070E _56 Audio / Visual / Telematics _061931 AUDIO / VIDEO _0301727 STEREO JACK ADAPTER ASSEMBLY A

AUDIO / VIDEO  STEREO JACK ADAPTER ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 58810J 8.REMOVE CONSOLE BOX ASSEMBLY

Hide 55440D 10.REMOVE INSTRUMENT PANEL BOX ASSEMBLY

Hide 11.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 86190C 12.REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY

a.
E227975

Disengage the 2 claws and remove the No. 1 stereo jack adapter assembly.