86011R
1.INSTALL RADIO SETTING CONDENSER
Engage the claw to install a new terminal cover to the wire harness.
Make sure to hold the wire harness on the crimping side of the terminal when installing the wire harness from the terminal cover.
Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.
Do not use excessive force when inserting the wire harness into the terminal cover.
If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.
Engage the 6 claws to install the 2 new terminal covers with wire harness to a new condenser.
Do not use excessive force when inserting the terminal cover into the condenser.
If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.
Engage the claw to insert the cover as shown in the illustration.
Engage the clamp to temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
62480A
2.INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH
64740C
3.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
81250
4.INSTALL NO. 2 ROOM LIGHT ASSEMBLY
73570
5.CONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH (for Lower Side)
73370C
6.CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
55548C
7.INSTALL NO. 2 CUP HOLDER
64713F
8.INSTALL FRONT DECK SIDE TRIM COVER LH
58460D
9.INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY
64721G
10.INSTALL NO. 1 DECK TRIM COVER
62332A
11.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
67918A
12.INSTALL REAR DOOR SCUFF PLATE LH
13.INSTALL REAR NO. 2 SEAT ASSEMBLY
72128C
14.INSTALL SEAT TRACK BRACKET COVER LH
72159H
15.INSTALL REAR SEAT TRACK BRACKET COVER
72127D
16.INSTALL SEAT TRACK BRACKET COVER RH
67935A
17.INSTALL BACK DOOR SCUFF PLATE
64910J
18.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
64995
19.INSTALL DECK FLOOR BOX RH
64993
20.INSTALL REAR DECK FLOOR BOX
58411A
21.INSTALL NO. 1 DECK BOARD
58412A
22.INSTALL NO. 2 DECK BOARD
58410B
23.INSTALL DECK BOARD ASSEMBLY