These DTCs are stored when a malfunction occurs in the No. 1 amplifier antenna assembly.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15C0 | No. 1 amplifier antenna assembly malfunction | ·
Antenna cord sub-assembly ·
No. 2 antenna cord sub-assembly ·
No. 1 amplifier antenna assembly ·
Radio and display receiver assembly |
| B15C1 | No. 1 amplifier antenna assembly power source malfunction |
Check that the antenna cord sub-assembly, No. 2 antenna cord sub-assembly or No. 1 amplifier antenna assembly is properly installed and does not have any sharp bends, pinching or loose connections before performing the following inspection procedure (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).
Replace the antenna cord sub-assembly with a new or known good one.
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
NG
Replace the No. 2 antenna cord sub-assembly with a new or known good one.
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
NG
Replace the No. 1 amplifier antenna assembly with a new or known good one.
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
NG