Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER › 2014.11–2016.05
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301734 NAVIGATION RECEIVER A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

(See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for Navigation Receiver Type)>PRECAUTION)

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55440D 9.REMOVE INSTRUMENT PANEL BOX ASSEMBLY

Hide 10.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 11.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

a.
E300947

Remove the 4 bolts.


b.
E300948

Disengage the 5 claws and 2 guides.


c.

Disconnect each connector and remove the navigation receiver assembly with bracket.


Hide 86211J 12.REMOVE NO. 1 RADIO RECEIVER BRACKET

a.
E300949

Remove the 3 screws and No. 1 radio receiver bracket.


Hide 86212C 13.REMOVE NO. 2 RADIO RECEIVER BRACKET

a.
E300950

Remove the 3 screws and No. 2 radio receiver bracket.


Hide 86120L 14.REMOVE NAVIGATION RECEIVER ASSEMBLY