Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › HARD DISK DRIVE › 2012.03–2013.08
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301735 HARD DISK DRIVE A

NAVIGATION / MULTI INFO DISPLAY  HARD DISK DRIVE  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

A hard disk drive (HDD) is built into the navigation receiver assembly to store map and other data and is used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the navigation receiver assembly.

·

When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.



Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55440D 9.REMOVE INSTRUMENT PANEL BOX ASSEMBLY

Hide 10.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 86212C 12.REMOVE NO. 2 RADIO RECEIVER BRACKET

HINT:

Use the same procedure as for the No. 1 radio receiver bracket (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER>REMOVAL).


Hide 86271L 13.REMOVE HARD DISK DRIVE

a.
E229266

Remove the 2 screws.


b.

Disengage the 2 guides to remove the cover.


c.
E229267

Pull out the hard disk drive from the navigation receiver assembly in the direction shown by the arrow in the illustration to remove it.