This DTC is stored when the hard disk drive which is built into the navigation ECU sub-assembly has an initialization malfunction or read/write errors occur more than a specified number of times.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15B8 | Hard Disk Drive (HDD) malfunction | Hard disk drive |
Enter the "HDD Check" screen. Refer to Check Hard Disk Drive in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK).
Select "HDD Check" and check the result.
"OK" is displayed.
After "HDD Check" is selected, it may take a while until the result is displayed.
OK
NG
Clear the DTCs (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
The hard disk drive may be malfunctioning even if DTC B15B8 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG