Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type) › 2014.11–2020.08
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301739 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  AVC-LAN Circuit  


DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transmits switch signals via AVC-LAN communication.

If a short to +B or short to ground occurs in an AVC-LAN communication line, the navigation system will not function normally because communication is not possible.

WIRING DIAGRAM

E308009E02
1.899,1.436 2.117,1.588 0.217,0.152 10 10 1.885,0.902 2.103,1.053 0.217,0.152 10 11 4.253,0.825 4.470,0.976 0.217,0.152 10 7 4.253,1.369 4.470,1.521 0.217,0.152 10 8 2.901,0.832 3.118,0.983 0.217,0.152 10 7 2.901,1.369 3.118,1.521 0.217,0.152 10 8 5.27,2.122 6.619,2.488 1.349,0.366 10 Stereo Component Amplifier Assembly*2 5.27,1.959 5.764,2.111 0.494,0.152 10 L31 3.059,1.982 4.347,2.329 1.288,0.348 10 Radio and Display Receiver Assembly 0.963,3.257 2.980,3.409 2.016,0.152 10 : AVC-LAN Communication Line 5.45,1.566 5.864,1.718 0.414,0.152 10 TX- 5.45,1.03 5.864,1.182 0.414,0.152 10 TX+ 1.513,1.024 1.826,1.176 0.313,0.152 10 TX+ 1.555,1.568 1.826,1.720 0.271,0.152 10 TX- 3.736,1.566 4.095,1.718 0.359,0.152 10 TX1- 3.712,1.03 4.095,1.182 0.383,0.152 10 TX1+ 3.197,1.566 3.613,1.718 0.417,0.152 10 TX3- 3.19,1.03 3.660,1.182 0.470,0.152 10 TX3+ 5.242,1.467 5.459,1.619 0.217,0.152 10 7 5.242,0.923 5.459,1.075 0.217,0.152 10 8 0.761,1.959 1.255,2.111 0.494,0.152 10 L64 0.761,2.104 2.211,2.255 1.451,0.152 10 Parking Assist ECU*1 3.376,2.995 5.892,3.147 2.515,0.152 10 *1: w/ Intelligent Parking Assist System 3.376,3.303 5.892,3.455 2.515,0.152 10 *2: for 8 Speakers 2.287,1.154 2.504,1.305 0.217,0.152 10 *1 2.287,1.7 2.504,1.852 0.217,0.152 10 *1 4.781,1.154 4.998,1.305 0.217,0.152 10 *2 4.781,1.7 4.998,1.852 0.217,0.152 10 *2 4.186,1.031 4.442,1.182 0.255,0.152 10 L35 4.186,1.563 4.442,1.715 0.255,0.152 10 L35 2.783,1.025 3.253,1.177 0.470,0.152 10 L169 2.783,1.565 3.253,1.716 0.470,0.152 10 L169

CAUTION / NOTICE / HINT

HINT:

The radio and display receiver assembly is the master unit.


PROCEDURE

1.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY
a.

Remove the radio and display receiver assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER>REMOVAL).


b.
U191437E02
1.781,1.49 2.115,2.01 false 1.646,1.5 1.365,2.021 false 1.656,3.448 1.979,3.969 false 1.521,3.448 1.24,3.969 false 1.583,0.667 1.885,0.865 0.302,0.198 10 false L35 0.125,0.063 0.427,0.26 0.302,0.198 10 false *a 1.167,2.031 1.531,2.229 0.365,0.198 10 false TX1- 2,2.031 2.396,2.229 0.396,0.198 10 false TX1+ 1.542,2.667 1.896,2.865 0.354,0.198 10 false L169 2.031,2.656 2.385,2.854 0.354,0.198 10 false *B 2.031,0.677 2.385,0.875 0.354,0.198 10 false *A 1.052,3.99 1.417,4.188 0.365,0.198 10 false TX3- 1.854,3.99 2.25,4.188 0.396,0.198 10 false TX3+

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L35-7 (TX1+) - L35-8 (TX1-)*1 Always 60 to 80 Ω
L169-7 (TX3+) - L169-8 (TX3-)*2 Always 60 to 80 Ω


*1: for 8 Speakers

*2: w/ Intelligent Parking Assist System


Text in Illustration
*A for 8 Speakers
*B w/ Intelligent Parking Assist System
*a Component without harness connected
(Radio and Display Receiver Assembly)



OK

2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)
a.

Disconnect the L35*1 or L169*2 radio and display receiver assembly connector.


b.

Disconnect the L31 stereo component amplifier assembly connector.*1


c.

Disconnect the L64 parking assist ECU connector.*2


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L35-7 (TX1+) - L31-8 (TX+)*1 Always Below 1 Ω
L35-8 (TX1-) - L31-7 (TX-)*1 Always Below 1 Ω
L169-7 (TX3+) - L64-11 (TX+)*2 Always Below 1 Ω
L169-8 (TX3-) - L64-10 (TX-)*2 Always Below 1 Ω
L35-7 (TX1+) - Body ground*1 Always 10 kΩ or higher
L35-8 (TX1-) - Body ground*1 Always 10 kΩ or higher
L169-7 (TX3+) - Body ground*2 Always 10 kΩ or higher
L169-8 (TX3-) - Body ground*2 Always 10 kΩ or higher


*1: for 8 Speakers

*2: w/ Intelligent Parking Assist System




OK

3.INSPECT MALFUNCTIONING PARTS

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT MALFUNCTIONING PARTS
a.

Disconnect and reconnect each slave unit one by one until the master unit returns to normal.

HINT:
·

Check all slave units.

·

If disconnecting a slave unit causes the master unit to return to normal, the slave unit is defective and should be replaced.



OK:

Master unit returns to normal.




OK

REPLACE MALFUNCTIONING PARTS

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY