Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type) › 2014.11–2020.08
RM2070E _56 Audio / Visual / Telematics _061932 NAVIGATION / MULTI INFO DISPLAY _0301739 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Vehicle Position Mark Deviates Greatly  


CAUTION / NOTICE / HINT

NOTICE:
·

If standard size tires are not installed, the vehicle position mark may deviate from the route even if the navigation system is operating normally.

·

Make sure that standard size tires are installed to the vehicle before inspection.



PROCEDURE

1.CHECK CABIN
a.

Check the cabin for any object that might interrupt radio reception or additional devices which use radio waves on the instrument panel. If such an object exists, remove it and check if the vehicle position mark returns to the appropriate position.

HINT:

The GPS uses extremely faint radio waves originating from satellites. If the signal is interrupted by obstructions or other radio waves, the GPS may not be able to properly receive the signal.


OK:

After driving for a while, the vehicle position mark returns to the appropriate position.




OK

END

NG

2.CHECK SURROUNDINGS
2.CHECK SURROUNDINGS
a.

Check if the vehicle is in a location where GPS signal reception is poor. If the vehicle is in such a place, relocate the vehicle and check if the vehicle position mark returns to the appropriate position.

HINT:

The GPS uses 24 satellites in 6 orbits. At any point in time, 4 satellites should be able to pinpoint your vehicle. However, GPS signals may not reach the vehicle due to influence from the surroundings, vehicle direction and time. For examples, see the following illustration.


I100196E28
0.162,0.093 0.385,0.296 0.223,0.203 10 *a 1.245,2.067 1.449,2.270 0.204,0.203 10 *b 3.337,2.142 3.573,2.346 0.236,0.204 10 *c 3.42,4.055 3.611,4.258 0.191,0.204 10 *f 1.207,3.986 1.409,4.189 0.202,0.203 10 *e 5.238,2.118 5.471,2.321 0.233,0.203 10 *d 5.5,4.069 5.691,4.272 0.191,0.204 10 *g

Text in Illustration
*a Example *b In a tunnel
*c In a building *d Under an overpass
*e On a forest or tree-lined path *f Between tall buildings
*g Under a cliff or overhang - -

OK:

After driving for a while, the vehicle position mark returns to the appropriate position.




OK

END (SYSTEM RETURNS TO NORMAL)

NG

3.CHECK SYSTEM SENSORS (OPERATION CHECK)
3.CHECK SYSTEM SENSORS (OPERATION CHECK)
E283415

a.

Enter the "System Sensors Check" screen.

Refer to Check System Sensors in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Radio and Display Type)>OPERATION CHECK).


b.

Check how many of the following codes appear in the "Reception number".

HINT:

T or P appears.


OK:

At least 3 codes appear.




OK

4.CHECK VEHICLE SIGNAL (OPERATION CHECK)

NG

4.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.

Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Radio and Display Type)>OPERATION CHECK).


b.
E225801

Check that the display changes between ON and OFF according to shift lever operation.

OK:
Shift State Display
Except reverse (R) OFF
Reverse (R) ON


HINT:

The display is updated once per second. It is normal for the display to lag behind the actual shift lever operation.




OK

NG

GO TO "REVERSE SIGNAL DOES NOT CHANGE IN VEHICLE SIGNAL CHECK MODE" IN PROBLEM SYMPTOMS TABLE