These DTCs are stored when a malfunction occurs in the navigation receiver assembly.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1550 | When any of the following conditions is met:
·
DAB tuner decoder malfunction ·
DAB tuner audio output section malfunction ·
DAB tuner decoder RF/IF malfunction ·
DAB tuner control communication error ·
DAB tuner OFDM error ·
DAB tuner memory error |
Navigation receiver assembly |
| B15A0 | When either of the following conditions is met:
·
Bus malfunction ·
EEPROM error |
|
| B15AD | When any of the following conditions is met:
·
Short to ground or +B or open occurs in gyro signal circuit ·
Gyro sensor malfunction ·
GPS receiver malfunction |
|
| B15B0 | Picture circuit (TFT unit) malfunction | |
| B15B3 | When any of the following conditions is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
|
| B15B4 | When any of the following conditions is met:
·
Mechanism drive signal malfunction ·
Load/Eject malfunction ·
Read mechanism malfunction ·
Mechanical malfunction |
|
| B15B7 | "Bluetooth" module malfunction |
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG