This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral cable with sensor sub-assembly that indicates a power supply system problem.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1625 | Open or short in steering angle sensor +B | ·
Harness or connector ·
Steering angle sensor (spiral cable with sensor sub-assembly) |
When the "System initializing" message is displayed on the navigation ECU sub-assembly after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the L51 spiral cable with sensor sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L51-2 (ESS) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L51-5 (IG) - L51-2 (ESS) | Power switch on (IG) | 11 to 14 V |
| L51-6 (BAT) - L51-2 (ESS) | Power switch off | 11 to 14 V |
| *a | Front view of wire harness connector
(to Spiral Cable with Sensor Sub-assembly) |
OK
NG