Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301800 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  REMOVAL  


PROCEDURE

Hide 45100 1.REMOVE STEERING WHEEL ASSEMBLY

Hide 45286 2.REMOVE STEERING COLUMN COVER

Hide 84307 3.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the negative (-) auxiliary battery cable connected and the power switch on (IG).

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the negative (-) auxiliary battery cable connected and the power switch on (IG).

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

·

Do not remove the spiral cable from the steering sensor.



a.
B226987E02
1.338,2.866 1.508,3.044 0.171,0.177 10 *a 0.854,2.819 0.989,2.955 0.989,2.955 1.318,2.955 false

Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.

Text in Illustration
*a Slider

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



b.

Disconnect the other connector from the spiral cable with sensor sub-assembly.


c.
B312043

Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.