The parking assist ECU receives back door lock assembly open/close signals from the main body ECU (multiplex network body ECU) via CAN communication. When the back door is open, the camera aiming cannot be adjusted correctly because the rear television camera assembly is installed on the back door. Therefore, when adjusting the camera aiming calibration while the back door is open, a back door open warning message will be displayed on the screen and camera aiming adjustment will be canceled.
When the "System initializing" message is displayed on the navigation ECU sub-assembly after the auxiliary battery cable has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>INITIALIZATION).
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the advanced parking guidance system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION).
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body / Main Body / Data List.
Check for proper functioning of the following item using the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Back Door Courtesy SW | Back door courtesy switch signal/ON or OFF | ON: Back door open
OFF: Back door closed |
- |
The back door courtesy switch functions as specified in the normal condition column.
OK
NG
Disconnect the L7 main body ECU (multiplex network body ECU) connector.
Disconnect the V11 back door lock assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L7-19 (BCTY) - V11-3 (D+) | Always | Below 1 Ω |
| L7-19 (BCTY) - Body ground | Always | 10 kΩ or higher |
| V11-1 (ACT-) - Body ground | Always | Below 1 Ω |
OK
NG
Remove the back door lock assembly (See page Vehicle Interior>DOOR LOCK>BACK DOOR LOCK>REMOVAL).
Check the operation of the door lock motor.
Move the door lock to the lock position.
Apply auxiliary battery voltage to the door lock motor and check the operation of the door lock motor.
| Connection | Result |
|---|---|
| Auxiliary battery positive (+) → 2 (ACT+)
Auxiliary battery negative (-) → 1 (ACT-) |
Unlocks |
Check the operation of the door courtesy switch.
Measure the resistance according to the value(s) in the table below.
| Measurement Condition | Condition | Specified Condition |
|---|---|---|
| 1 (ACT-) - 3 (D+) | Locked | 10 kΩ or higher |
| 1 (ACT-) - 3 (D+) | Unlocked | Below 1 Ω |
| *a | Component without harness connected
(Back Door Lock Assembly) |
| *b | Lock |
| *c | Unlock |
OK
NG