Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR › 2012.03–2014.11
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301743 ULTRASONIC SENSOR A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR  INSTALLATION  


PROCEDURE

Hide 89348 1.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

a.
E228655E02
0.979,0.49 0.802,0.323 false 2.219,0.594 2.427,0.375 false 2.479,0.25 2.635,0.406 0.156,0.156 10 false *a 0.594,0.177 0.75,0.333 0.156,0.156 10 false *b

Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the front bumper assembly.

Text in Illustration
*a Snap
*b Keyhole

NOTICE:
·

Do not damage the front bumper with the protrusion when installing the retainer.

·

Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the front bumper.



HINT:
·

When installing the retainer, align the keyhole and snap as shown in the illustration.

·

The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.




Hide 89341A 2.INSTALL NO. 1 ULTRASONIC SENSOR

a.

Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.

NOTICE:

Push the No. 1 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.


HINT:

Use the same procedure for the RH side and LH side.



Hide 89348D 3.INSTALL ULTRASONIC SENSOR CLIP

a.

Engage the 4 claws to install the ultrasonic sensor clip.


b.

Engage the clamp.


c.

Connect the connector.

HINT:

Use the same procedure for the RH side and LH side.



Hide 4.INSTALL FRONT BUMPER ASSEMBLY