Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2012.03–2014.11
RM2070E _59 Vehicle Exterior _061955 EXTERIOR PANELS / TRIM _0301930 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

w/ Headlight Cleaner System:

i.

Connect the headlight cleaner hose.



b.

Connect each connector.


c.
B315881

Install the front bumper assembly as shown in the illustration.


d.
B274672

Engage the 3 claws.

HINT:

Use the same procedure for the RH side and LH side.



e.

Install the 3 clips and 4 bolts.

Torque:
Bolt : 5.5 N*m (56 kgf*cm, 49 in.*lbf)


f.
B315882E02
2.313,4.333 3.281,4.333 3.281,4.333 3.281,3.823 false 3.104,3.948 3.104,4.333 false 2.573,3.948 2.573,4.333 false 1.156,4.333 0.177,4.333 0.177,4.333 0.177,3.844 false 0.354,4.021 0.354,4.333 false 0.885,4.094 0.885,4.333 false 2.833,1.271 2.635,1.167 false 0.635,1.271 0.833,1.167 false 2.146,4.25 2.333,4.417 0.188,0.167 10 false *1 1.177,4.25 1.365,4.417 0.188,0.167 10 false *1 2.865,1.219 3.052,1.385 0.188,0.167 10 false *2 0.479,1.208 0.667,1.375 0.188,0.167 10 false *2

Install the 6 screws <A>.

Text in Illustration
*1 Screw <A>
*2 Screw <B>


g.

Install the 2 screws <B>.

Torque:
Screw <B> : 3.0 N*m (31 kgf*cm, 27 in.*lbf)


h.
B285686E02
2.771,0.927 3.052,1.167 0.281,0.24 10 false *b 2.188,0.917 2.469,1.156 0.281,0.24 10 false *a

Install the pin hold clip.

Text in Illustration
*a Correct
*b Incorrect

NOTICE:

Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.


HINT:

Use the same procedure for the RH side and LH side.



Hide 53289A 2.INSTALL RADIATOR SUPPORT OPENING COVER

a.

Engage the 3 guides.


b.

Install the radiator support opening cover with the 3 clips.


Hide 3.ADD WASHER FLUID (w/ Headlight Cleaner System)

Hide 4.ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)