Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR › from 2014.11
RM2070E _56 Audio / Visual / Telematics _061933 PARK ASSIST / MONITORING _0301743 ULTRASONIC SENSOR A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR  INSTALLATION  


PROCEDURE

Hide 89348 1.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

HINT:

Use the same procedure for all No. 1 ultrasonic sensor retainers.


a.
E305609E03
1.104,0.5 1.302,0.26 false 2.208,0.594 2.49,0.24 false 2.521,0.146 2.677,0.292 0.156,0.146 10 false *b 1.313,0.156 1.469,0.302 0.156,0.146 10 false *a

Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the front bumper assembly.

Text in Illustration
*a Cutout
*b Protrusion

NOTICE:
·

Do not damage the front bumper assembly with the protrusion when installing the No. 1 ultrasonic sensor retainer.

·

Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the No. 1 ultrasonic sensor retainer and surface of the front bumper assembly.



HINT:
·

When installing the retainer, align the cutout and protrusion as shown in the illustration.

·

This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.




Hide 89341A 2.INSTALL NO. 1 ULTRASONIC SENSOR

HINT:

Use the same procedure for all No. 1 ultrasonic sensors.


a.

Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.

NOTICE:

Push the No. 1 ultrasonic sensor retainer from the outside of the front bumper assembly when there is a gap between the No. 1 ultrasonic sensor retainer and the front bumper assembly surface. In this case, do not push on the No. 1 ultrasonic sensor.



b.

Connect the connector.


Hide 3.INSTALL FRONT BUMPER ASSEMBLY