1.REMOVE FRONT BUMPER ASSEMBLY
89348D
2.REMOVE ULTRASONIC SENSOR CLIP
Disconnect the connector.
Disengage the clamp.
Disengage the 4 claws to remove the ultrasonic sensor clip.
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
89341A
3.REMOVE NO. 1 ULTRASONIC SENSOR
Disengage the 2 claws to remove the No. 1 ultrasonic sensor.
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.
89348
4.REMOVE NO. 1 ULTRASONIC SENSOR RETAINER
Disengage the 2 claws and remove the No. 1 ultrasonic sensor retainer.
The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.