Home › Power Source / Network › 2ZR-FXE (BATTERY / CHARGING) › AUXILIARY BATTERY › 2014.11–2016.05
RM2070E _57 Power Source / Network _061934 2ZR-FXE BATTERY / CHARGING _0301748 AUXILIARY BATTERY A

2ZR-FXE BATTERY / CHARGING  AUXILIARY BATTERY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 8.REMOVE AUXILIARY BATTERY

a.
A251301

Open the auxiliary battery terminal cap.


b.

Loosen the nut, and disconnect the positive (+) auxiliary battery cable.


c.
A251302

Disconnect the auxiliary battery thermometer sensor connector.


d.

Disconnect the auxiliary battery hose.


e.

Loosen the nut, and remove the bolt.


f.

Remove the auxiliary battery clamp.


g.

Remove the auxiliary battery.