Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM › 2012.03–2016.05
RM2070E _57 Power Source / Network _061936 NETWORKING _0301753 LIN COMMUNICATION SYSTEM C

NETWORKING  LIN COMMUNICATION SYSTEM  B2785  Communication Malfunction between ECUs Connected by LIN  


DESCRIPTION

The certification ECU (smart key ECU assembly) monitors communication between all the ECUs connected to the certification bus lines. When the certification ECU (smart key ECU assembly) detects errors in communication with all the ECUs connected to the certification bus lines at a set interval and 3 times in a row, DTC B2785 will be stored.

DTC No. DTC Detection Condition Trouble Area
B2785
·

Errors in LIN communication between ECUs and an open or short in communication lines

·

LIN communication from the certification ECU (smart key ECU assembly) detects errors in communication 3 times in a row.


·

Certification ECU (smart key ECU assembly)

·

Power management control ECU

·

Transmission control ECU assembly

·

ID code box (immobiliser code ECU)

·

Wire harness or connector



WIRING DIAGRAM

B408162E02
2.656,0.469 3.271,0.667 0.615,0.198 10 false LIN1 3.042,0.302 3.656,0.5 0.615,0.198 10 false 3 4.427,0.302 5.042,0.5 0.615,0.198 10 false 29 4.677,0.458 5.292,0.656 0.615,0.198 10 false LIN 4.677,2.323 5.292,2.521 0.615,0.198 10 false LIN 4.427,2.167 5.042,2.365 0.615,0.198 10 false 24 3.042,2.167 3.656,2.365 0.615,0.198 10 false 11 2.635,2.323 3.25,2.521 0.615,0.198 10 false LIN2 1.438,1.031 2.052,1.229 0.615,0.198 10 false L10 1.438,1.177 3.042,1.781 1.604,0.604 10 false ID Code Box (Immobiliser Code ECU) 4.646,1.177 6.188,1.74 1.542,0.563 10 false Certification ECU (Smart Key ECU Assembly) 4.646,1.031 5.958,1.219 1.313,0.188 10 false L62 4.615,2.885 5.229,3.083 0.615,0.198 10 false A24 4.625,3.042 6.26,3.5 1.635,0.458 10 false Transmission Control ECU Assembly 1.146,3.01 3.573,3.271 2.427,0.26 10 false Power Management Control ECU 1.146,2.844 1.76,3.042 0.615,0.198 10 false L6 0.708,3.417 3.135,3.677 2.427,0.26 10 false : LIN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

If the certification ECU (smart key ECU assembly) is replaced, register the key.

·

If the transmission control ECU assembly is replaced, register the ECU code.

·

If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID.

·

When using the GTS to troubleshoot with the power switch off:

Connect the GTS to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the GTS and vehicle begins.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - EACH ECU)
a.

Disconnect the L62, L6, L10 and A24 connectors.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L62-29 (LIN) - A24-24 (LIN) Always Below 1 Ω
L62-29 (LIN) - L6-11 (LIN2) Always Below 1 Ω
L62-29 (LIN) - L10-3 (LIN1) Always Below 1 Ω
L62-29 (LIN) - Body ground Always 10 kΩ or higher


Standard Voltage:
Tester Connection Condition Specified Condition
L62-29 (LIN) - Body ground Always Below 1 V




OK

2.CHECK DTC OUTPUT (TRANSMISSION CONTROL ECU ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK DTC OUTPUT (TRANSMISSION CONTROL ECU ASSEMBLY)
a.

Reconnect the L62, L6 and L10 connectors.



c.

Recheck for DTCs.

Result:
Result Proceed to
DTC B2785 is output A
DTC B2785 is not output B




A

3.CHECK DTC OUTPUT (POWER MANAGEMENT CONTROL ECU)

B

REPLACE TRANSMISSION CONTROL ECU ASSEMBLY

3.CHECK DTC OUTPUT (POWER MANAGEMENT CONTROL ECU)
a.

Reconnect the A24 connector.


b.

Disconnect the L6 connector.



d.

Recheck for DTCs.

Result:
Result Proceed to
DTC B2785 is output A
DTC B2785 is not output B




A

4.CHECK DTC OUTPUT (ID CODE BOX (IMMOBILISER CODE ECU))

B

4.CHECK DTC OUTPUT (ID CODE BOX (IMMOBILISER CODE ECU))
a.

Reconnect the L6 connector.


b.

Disconnect the L10 connector.



d.

Recheck for DTCs.

Result:
Result Proceed to
DTC B2785 is output A
DTC B2785 is not output B




A

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

B

REPLACE ID CODE BOX (IMMOBILISER CODE ECU)