This DTC is stored when LIN communication between the power window regulator motor assembly (for rear RH side) and main body ECU (multiplex network body ECU) stops for 10 seconds or more.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2323 | No communication between power window regulator motor assembly (for rear RH side) and main body ECU (multiplex network body ECU) for 10 seconds or more. | ·
Power window regulator motor assembly (for rear RH side) ·
Main body ECU (multiplex network body ECU) ·
Instrument panel junction block assembly ·
Wire harness or connector ·
DOOR RR fuse |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When a power window regulator motor assembly is replaced or removed and reinstalled, it requires initialization (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
When using the GTS to troubleshoot with the power switch off:
Connect the GTS to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the GTS and vehicle begins.
Remove the instrument panel junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
This inspection is to check the LIN line in the instrument panel junction block assembly that connects the wire harness to the built-in main body ECU (multiplex network body ECU).
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2A-27 (LIN2) - MB-16 (LIN2) | Always | Below 1 Ω |
| 2A-27 (LIN2) - Body ground | Always | 10 kΩ or higher |
| *1 | Component without harness connected
(Instrument Panel Junction Block Assembly) |
*2 | Component without harness connected
(Instrument Panel Junction Block Assembly) |
OK
NG
Disconnect the P4 power window regulator motor assembly (for rear RH side) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2A-27 (LIN2) - P4-9 (LIN) | Always | Below 1 Ω |
| 2A-27 (LIN2) - Body ground | Always | 10 kΩ or higher |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P4-2 (B) - Body ground | Power switch off | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P4-1 (GND) - Body ground | Always | Below 1 Ω |
| *1 | Front view of wire harness connector
(to Power Window Regulator Motor Assembly (for Rear RH Side)) |
OK
NG
Replace the power window regulator motor assembly (for rear RH side) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW REGULATOR MOTOR (for Rear Door)>REMOVAL).
NEXT
Clear the DTC (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
Check for DTCs.
DTC B2323 is not output.
OK
NG