Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK › 2014.11–2016.05
RM2070E _58 Vehicle Interior _061937 DOOR LOCK _0301762 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 69284D 8.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 9.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 74262 10.REMOVE REAR DOOR ARMREST COVER

Hide 67604 11.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67628 12.REMOVE REAR DOOR TRIM BRACKET

Hide 67842E 13.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 68152C 14.REMOVE REAR DOOR GLASS RUN

Hide 67408D 15.REMOVE REAR DOOR WINDOW GUIDE SUB-ASSEMBLY

Hide 67872 16.DISCONNECT REAR DOOR WEATHERSTRIP

a.
B282562

Separate the rear door weatherstrip to the extent that the 2 installation screws of the rear door rear guide seal can be removed.


Hide 67488C 17.REMOVE REAR DOOR REAR GUIDE SEAL

Hide 68104 18.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 69060A 19.REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY

a.
B387655E09
2.938,2.323 3.083,2.229 true 3.063,2.083 3.281,2.24 0.219,0.156 10 true *a

Using a T30 "TORX" socket wrench, remove the 3 screws.

Text in Illustration
*a Release Plate


b.

Move the rear door lock with motor assembly downward to disconnect in from the release plate of the rear door outside handle frame sub-assembly and remove the rear door lock with motor assembly and cables as a unit.


c.

When reusing the rear door lock with motor assembly:

i.
B387657

Remove the door lock wiring harness seal from the rear door lock with motor assembly.



Hide 69038A 20.REMOVE REAR DOOR LOCK COVER SUB-ASSEMBLY (w/o Double Locking System)

Hide 69740D 21.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)

Hide 69740D 22.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)

Hide 69780B 23.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)

Hide 69780B 24.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)