Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM › from 2016.05
RM2070E _58 Vehicle Interior _061938 THEFT DETERRENT / KEYLESS ENTRY _0301769 ENGINE IMMOBILISER SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  B279C  Theft Deterrent System Presence Detection  


DESCRIPTION

This code is stored when a hybrid vehicle control ECU that is incompatible with the engine immobiliser system is installed to the vehicle.

DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation
B279C A hybrid vehicle control ECU that is incompatible with the engine immobiliser system is installed (1 trip detection logic*). Hybrid vehicle control ECU Check for DTCs.

*: Only output while a malfunction is present.


Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Hybrid control system cannot be started -

Related Data List and Active Test
DTC Code Data List and Active Test
B279C -

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.


PROCEDURE

1.REPLACE CURRENT HYBRID VEHICLE CONTROL ECU WITH PROPER HYBRID VEHICLE CONTROL ECU
a.

Replace the current hybrid vehicle control ECU with the proper hybrid vehicle control ECU (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID VEHICLE CONTROL ECU>REMOVAL).



NEXT

2.CLEAR DTC
2.CLEAR DTC

NEXT

3.CHECK DTC OUTPUT
3.CHECK DTC OUTPUT
a.

Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).

HINT:

Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.


OK:

DTC B279C is not output.




OK

END (HYBRID VEHICLE CONTROL ECU WAS DEFECTIVE)

NG

USE SIMULATION METHOD TO CHECK