When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (multiplex network body ECU) transmits a signal to cause the horns to sound at intervals of 0.4 seconds.
Press the horn switch and check if the horns sound.
| Result | Proceed to |
|---|---|
| Horns sound | A |
| Horns do not sound | B |
A
B
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Vehicle Horn | Vehicle horns | ON / OFF | - |
| Result | Proceed to |
|---|---|
| The vehicle horns do not sound when operated through the GTS | A |
| The vehicle horns sound and stop correctly when operated through the GTS | B |
A
B
Remove the main body ECU (multiplex network body ECU) (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Disconnect the 2C instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2C-24 - MB-28 (HORN) | Always | Below 1 Ω |
| 2C-24 - Body ground | Always | 10 kΩ or higher |
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
OK
NG