Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › 2012.03–2016.05
RM2070E _58 Vehicle Interior _061939 LIGHTING (INT) _0301790 LIGHTING SYSTEM J

LIGHTING (INT)  LIGHTING SYSTEM  Power Switch Illumination Circuit  


DESCRIPTION

The illuminated entry system controls the power switch illumination.

WIRING DIAGRAM

E181483E06
1.927,2.664 2.222,2.818 0.295,0.154 10 L43 1.927,2.814 2.837,2.956 0.911,0.142 10 Power Switch 1.862,1.868 2.216,2.010 0.355,0.142 10 GND 1.693,1.868 1.803,2.033 0.110,0.165 10 5 4.295,1.868 4.676,2.010 0.382,0.142 10 SWIL 5.605,1.759 5.986,1.901 0.382,0.142 10 SWIL 4.731,1.868 4.910,2.017 0.179,0.149 10 11 5.375,1.703 5.555,1.852 0.179,0.149 10 11 5.139,2.814 5.433,2.963 0.294,0.149 10 L62 5.139,2.987 7.010,3.304 1.871,0.318 10 Certification ECU (Smart Key ECU Assembly)

CAUTION / NOTICE / HINT

NOTICE:

Check that the light intensity of the light control rheostat is set to maximum.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Entry&Start / Active Test.


e.

Check that the illumination operates.

Entry&Start
Tester Display Test Part Control Range Diagnostic Note
Power/Engine SW Light Power switch light ON/OFF When performing this Active Test, make sure the following condition is met:
The power switch illumination is off (15 seconds or more have elapsed since it turned from on to off) and the power switch is on (ACC) or on (IG), or the hybrid control system is running.

OK:

Power switch illumination comes on.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT POWER SWITCH
2.INSPECT POWER SWITCH

b.

Inspect the power switch (See page Engine / Hybrid System>2ZR-FXE (STARTING)>POWER SWITCH>INSPECTION).

OK:

Power switch illumination comes on.




OK

3.CHECK HARNESS AND CONNECTOR (POWER SWITCH - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) AND BODY GROUND)

NG

3.CHECK HARNESS AND CONNECTOR (POWER SWITCH - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) AND BODY GROUND)
a.

Disconnect the L62 certification ECU (smart key ECU assembly) connector.


b.

Disconnect the L43 power switch connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L43-11 (SWIL) - L62-11 (SWIL) Always Below 1 Ω
L43-11 (SWIL) - Body ground Always 10 kΩ or higher
L43-5 (GND) - Body ground Always Below 1 Ω




OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR