Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › 2012.03–2013.08
RM2070E _58 Vehicle Interior _061940 METER / GAUGE / DISPLAY _0301794 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  INSTALLATION  


PROCEDURE

Hide 83809 1.INSTALL COMBINATION METER SUB-ASSEMBLY

a.

Connect each connector.


b.

Engage the clamp.


c.
B284877

Move the combination meter sub-assembly as shown in the illustration.


d.

Install the combination meter sub-assembly with the 4 screws.


Hide 55404D 2.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55085 3.INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 55406B 4.INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 5.INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).