Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › 2014.11–2016.05
RM2070E _58 Vehicle Interior _061940 METER / GAUGE / DISPLAY _0301794 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55440D 9.REMOVE INSTRUMENT PANEL BOX ASSEMBLY

Hide 10.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55406B 11.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55085 12.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 55404D 13.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 83809 14.REMOVE COMBINATION METER SUB-ASSEMBLY

a.
B283393E03
2.698,0.677 3.146,0.552 true 0.646,1.052 0.521,1.448 true 0.448,1.479 0.604,1.625 0.156,0.146 10 false *1 3.167,0.448 3.323,0.594 0.156,0.146 10 false *1

Apply protective tape to the areas shown in the illustration.

Text in Illustration
*1 Protective Tape


b.
B283392

Remove the 4 screws.


c.
B283394

Move the combination meter sub-assembly as shown in the illustration.


d.

Disengage the clamp.


e.

Disconnect each connector to remove the combination meter sub-assembly.