Home › Vehicle Interior › METER / GAUGE / DISPLAY › HEADUP DISPLAY SWITCH › 2012.03–2013.08
RM2070E _58 Vehicle Interior _061940 METER / GAUGE / DISPLAY _0301796 HEADUP DISPLAY SWITCH A

METER / GAUGE / DISPLAY  HEADUP DISPLAY SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55431B 9.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL

Hide 55480D 10.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55044B 11.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 12.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 84120 13.REMOVE HEADUP DISPLAY SWITCH ASSEMBLY

a.
E250135

Disengage the 4 claws and remove the headup display switch assembly.