45130
1.INSTALL HORN BUTTON ASSEMBLY
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Connect the airbag connector to the horn button assembly.
| *1 | Airbag Connector |
| *2 | Horn Connector |
| *3 | Airbag Connector Lock |
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector lock to install the airbag connector.
Connect the horn connector to the horn button assembly.
Push the horn button assembly to engage the 2 pins.
Make sure that the pins are securely inserted into the steering holes.
Make sure that the horn button assembly is securely installed.
45187
2.INSTALL LOWER NO. 3 STEERING WHEEL COVER
Engage the claw to install the lower No. 3 steering wheel cover.
45186
3.INSTALL LOWER NO. 2 STEERING WHEEL COVER
Engage the claw to install the lower No. 2 steering wheel cover.
4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64995
5.INSTALL DECK FLOOR BOX RH
64993
6.INSTALL REAR DECK FLOOR BOX
58411A
7.INSTALL NO. 1 DECK BOARD
58412A
8.INSTALL NO. 2 DECK BOARD
58410B
9.INSTALL DECK BOARD ASSEMBLY
45130
10.INSPECT HORN BUTTON ASSEMBLY
Make sure that the horn sounds.
If the horn does not sound, inspect the horn system (See page Vehicle Exterior>HORN>HORN SYSTEM>PROBLEM SYMPTOMS TABLE).
11. PERFORM DIAGNOSTIC SYSTEM CHECK
12.INSPECT SRS WARNING LIGHT