1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
58810J
8.REMOVE CONSOLE BOX ASSEMBLY
9.REMOVE INTEGRATION CONTROL AND PANEL
55431B
10.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL
55480D
11.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
12.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
55606
13.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
73900
14.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Remove the 4 bolts.
| *A | for LHD |
for LHD:
Disengage the 2 claws to disconnect the DLC3.
Disengage the 6 claws and 3 guides to remove the lower No. 1 instrument panel airbag assembly.
When removing the lower No. 1 instrument panel airbag assembly, do not pull the airbag wire harness.
Remove the clamp.
Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.
| *1 | Airbag Connector Lock |
| *2 | Airbag Connector |
| *a | Protective Tape |
Disconnect the airbag connector to remove the lower No. 1 instrument panel airbag assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.