Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY › 2013.08–2014.11
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301803 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 62180A 1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

NOTICE:

Do not damage the roof headlining assembly.


a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.

Engage the 10 hooks to temporarily install the curtain shield airbag assembly.

NOTICE:
·

When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.

·

Do not twist the curtain shield airbag assembly when installing it.




d.

Install 10 new bolts in the order shown in the illustration.

B312051E02
1.167,1.521 1.271,1.677 0.104,0.156 10 false 1 1.469,1.5 1.573,1.656 0.104,0.156 10 true 2 0.354,1 0.458,1.156 0.104,0.156 10 true 3 2.323,0.865 2.427,1.021 0.104,0.156 10 true 5 3.302,0.885 3.406,1.042 0.104,0.156 10 true 6 4.354,1 4.458,1.156 0.104,0.156 10 true 7 5.479,1.271 5.583,1.427 0.104,0.156 10 true 8 6.177,1.583 6.281,1.74 0.104,0.156 10 true 9 6.688,1.813 6.865,1.969 0.177,0.156 10 false 10 0.677,0.99 0.781,1.146 0.104,0.156 10 true 4

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


e.
U154623E01
0.741,2.009 0.900,2.163 0.158,0.155 10 *1 1.307,2.099 0.924,2.099 false 1.782,0.952 1.940,1.107 0.158,0.155 10 *2

Connect the curtain shield airbag connector.

Text in Illustration
*1 Airbag Connector
*2 Airbag Connector Lock

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



f.

Push in the airbag connector lock.


Hide 2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.INSTALL ROOF HEADLINING ASSEMBLY