Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.
If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>DISASSEMBLY).
Use the same procedures for the LH side and RH side.
1.REMOVE FRONT SEAT ASSEMBLY
73920A
2.DISCONNECT FRONT SEAT AIRBAG ASSEMBLY
Disconnect the rubber band.
Disengage the fastener and separate the airbag wire harness.
w/ Seat Heater System:
Disengage the clamp and disconnect the seat heater wire harness.
3.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
73920A
4.REMOVE FRONT SEAT AIRBAG ASSEMBLY
Disengage the 2 clamps.
Remove the 2 nuts and the front seat airbag assembly.
The nuts must not be reused.
Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.