Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY › 2014.11–2016.05
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301805 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 89170A 1.INSTALL AIRBAG ECU ASSEMBLY

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.

Using SST, install the airbag ECU assembly with the 3 bolts.

SST
09961-00950  

B282172E02
4.427,0.948 4.844,1.365 4.844,1.365 5.313,1.365 false 5.042,0.25 5.219,0.417 0.177,0.167 10 false *a 5.354,1.281 5.667,1.458 0.313,0.177 10 false SST

Text in Illustration
*a Fulcrum Length - -

Torque:
without SST : 18 N*m (178 kgf*cm, 13 ft.*lbf)
with SST : 11 N*m (112 kgf*cm, 8 ft.*lbf)

NOTICE:
·

Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

·

This torque value is effective when SST is parallel to a torque wrench.

·

If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the airbag ECU assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

·

When the power switch is first turned on (IG) after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.




d.
B274075E02
1.563,1.51 1.302,1.771 1.302,1.771 0.708,1.771 true 0.5,1.688 0.677,1.854 0.177,0.167 10 false *1

Connect the connectors to the airbag ECU assembly as shown in the illustration.

Text in Illustration
*1 Waterproof Sheet

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



e.

Check that the waterproof sheet is properly set.


f.

Check that there is no looseness in the installation parts of the airbag ECU assembly.


Hide 58810J 2.INSTALL CONSOLE BOX ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).