Use the same procedure for the front passenger side of RHD and LHD vehicles.
The procedures listed below are for the front passenger side of an LHD vehicle.
69065A
1.INSTALL AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY
Engage the 2 claws to install the airbag cut off switch cylinder sub-assembly.
55435A
2.INSTALL INSTRUMENT PANEL FINISH PANEL END RH
3.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
55440D
4.INSTALL INSTRUMENT PANEL BOX ASSEMBLY
62311B
5.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62111C
6.INSTALL COWL SIDE TRIM BOARD RH
Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
67911B
7.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).
8.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64995
9.INSTALL DECK FLOOR BOX RH
64993
10.INSTALL REAR DECK FLOOR BOX
58411A
11.INSTALL NO. 1 DECK BOARD
58412A
12.INSTALL NO. 2 DECK BOARD
58410B
13.INSTALL DECK BOARD ASSEMBLY
14. PERFORM DIAGNOSTIC SYSTEM CHECK
15.INSPECT SRS WARNING LIGHT