Home › Vehicle Interior › PRE-CRASH SAFETY › SEAT BELT CONTROL ECU › 2012.03–2013.08
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301810 SEAT BELT CONTROL ECU A

PRE-CRASH SAFETY  SEAT BELT CONTROL ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55607 8.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55550 9.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 89815 12.REMOVE SEAT BELT CONTROL ECU

a.

for LHD:

i.
B283194

Disengage the 2 claws and remove the seat belt control ECU.



b.

for RHD:

i.
B265583

Disengage the 2 claws and remove the seat belt control ECU.