The seat belt control ECU receives information from the driving support ECU assembly using CAN communication and tightens the seat belt by operating the motor in the front seat outer belt assembly RH.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2000 | Short to B+ in the seat belt motor RH circuit continues for 1 second or more. | ·
Front seat outer belt assembly RH ·
Wire harness or connector (seat belt control ECU - front seat outer belt assembly RH) ·
Seat belt control ECU |
The pretensioner is built into the front seat outer belt assembly RH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Disconnect the S7 front seat outer belt assembly RH connector.
Do not remove the front seat outer belt assembly RH.
Turn the power switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S7-1 (MOR+) - Body ground | Power switch on (IG) | Below 1 V |
| S7-2 (MOR-) - Body ground | Power switch on (IG) | Below 1 V |
| *a | Component without harness connected
(Front Seat Outer Belt Assembly RH) |
Do not check a wrong connector.
OK
NG
Disconnect the L2 seat belt control ECU connector.
Turn the power switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L2-1 (MOR-) - Body ground | Power switch on (IG) | Below 1 V |
| L2-2 (MOR+) - Body ground | Power switch on (IG) | Below 1 V |
OK
NG