The seat belt control ECU receives information from the driving support ECU assembly using CAN communication and tightens the seat belt by operating the motor in the front seat outer belt assembly LH.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2007 | Open in the seat belt motor LH circuit continues for 1 second or more. | ·
Front seat outer belt assembly LH ·
Wire harness or connector (seat belt control ECU - front seat outer belt assembly LH) ·
Seat belt control ECU |
The pretensioner is built into the front seat outer belt assembly LH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Disconnect the R8 front seat outer belt assembly LH connector.
Do not remove the front seat outer belt assembly LH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R8-1 (MOL+) - R8-2 (MOL-) | Always | Below 20 Ω |
| *a | Component without harness connected
(Front Seat Outer Belt Assembly LH) |
Do not check a wrong connector.
OK
NG
Disconnect the L2 seat belt control ECU connector.
Using a service wire, connect 1 and 2 of the connector on the front seat outer belt assembly LH.
Do not forcibly insert the service wire into the terminals of the connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L2-3 (MOL+) - L2-4 (MOL-) | Always | Below 1 Ω |
Disconnect the service wire from the connector.
OK
NG