Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  B2015  Open in Right Side Upper MOS  B2016  Open in Right Side Lower MOS  B2020  Open in Left Side Upper MOS  B2021  Open in Left Side Lower MOS  B2025  Right Side Current Detection Circuit Malfunction Hi  B2026  Right Side Current Detection Circuit Malfunction Lo  B2027  Right Side Over-Current Malfunction  B2030  Left Side Current Detection Circuit Malfunction Hi  B2031  Left Side Current Detection Circuit Malfunction Lo  B2032  Left Side Over-Current Malfunction  B2035  Power Supply Relay Adherence Malfunction  B2040  EEPROM Malfunction  B2041  Fall of Raised Voltage  B2043  Fall of B+ Voltage  B2047  Seat Belt Control ECU Inner Circuit Malfunction  


DESCRIPTION

The DTCs above are stored during seat belt control ECU self-diagnosis.

HINT:
·

When DTC B2015 or B2016 is detected, DTCs B2026 and B2027 will not be detected.

·

When DTC B2020 or B2021 is detected, DTCs B2031 and B2032 will not be detected.



DTC No. DTC Detection Condition Trouble Area
B2015
B2016
B2020
B2021
B2025
B2026
B2027
B2030
B2031
B2032
B2035
B2040
B2041
B2043
B2047
While initial check is running and the power switch is on (IG), the seat belt control ECU detects an internal malfunction for 3 seconds. Seat belt control ECU

PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash / Trouble Codes.




f.

Turn the power switch off.


g.

Turn the power switch on (IG).


h.

Recheck for DTCs.

OK:

DTCs are not output.




OK

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION)

NG

REPLACE SEAT BELT CONTROL ECU