Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  B2036  Power Supply Relay Malfunction Open  


DESCRIPTION

If the seat belt control ECU judges that there is a malfunction in its internal circuit as a result of self-diagnosis, or if the power source voltage (+B) is not input to the seat belt control ECU, this DTC will be stored.

DTC No. DTC Detection Condition Trouble Area
B2036
·

Malfunction in seat belt control ECU

·

Power source voltage (+B) is not input to the seat belt control ECU.


·

Harness or connector

·

Seat belt control ECU



WIRING DIAGRAM

E228697E04
5.344,1.885 5.573,2.063 0.229,0.177 10 false L2 5.344,2.042 6.74,2.219 1.396,0.177 10 false Seat Belt Control ECU 3.917,1.26 4.219,1.438 0.302,0.177 10 false PSB 2.25,1.26 2.708,1.438 0.458,0.177 10 false DC/DC 0.208,1.083 1.552,1.26 1.344,0.177 10 false from Auxiliary Battery 5.615,1.073 5.823,1.25 0.208,0.177 10 false +B 4.729,1.094 4.938,1.271 0.208,0.177 10 false 2A 3.198,1.094 3.406,1.271 0.208,0.177 10 false 2E 4.792,0.896 4.885,1.073 0.094,0.177 10 false 5 5.448,1 5.542,1.177 0.094,0.177 10 false 7 3.25,0.896 3.344,1.073 0.094,0.177 10 false 1 3.219,1.708 4.865,2.146 1.646,0.438 10 false Instrument Panel Junction Block Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



PROCEDURE

1.INSPECT SEAT BELT CONTROL ECU (+B TERMINAL VOLTAGE)
a.
U191311E02
2.01,2.563 1.594,2.979 false 1.115,2.333 1.396,2.552 0.281,0.219 10 false L2 1.448,2.99 1.677,3.156 0.229,0.167 10 false +B 0.125,0.094 0.354,0.26 0.229,0.167 10 false *a

Disconnect the L2 seat belt control ECU connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L2-7 (+B) - Body ground Power switch off 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Seat Belt Control ECU)



OK

REPLACE SEAT BELT CONTROL ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (+B CIRCUIT)