Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2013.08–2014.11
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  B2064  Vehicle Type Signal Malfunction  


DESCRIPTION

The seat belt control ECU is connected to the main body ECU (multiplex network body ECU) using CAN communication.

The seat belt control ECU receives vehicle model information from the main body ECU (multiplex network body ECU) and determines whether the seat belt buckle switch information is for the driver seat or the passenger seat.

DTC B2064 is stored when CAN communication with the main body ECU (multiplex network body ECU) is normal and communication is available, but the steering wheel position information is not set or varies.

DTC No. DTC Detection Condition Trouble Area
B2064 Communication with the main body ECU is normal and received steering wheel position information is not set (three times in succession).
·

CAN communication system

·

Seat belt control ECU

·

Main body ECU (multiplex network body ECU)



CAUTION / NOTICE / HINT

HINT:

This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection.


PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)

b.

Recheck for DTCs.

OK:

CAN communication system DTC is not output.




OK

2.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)

NG

2.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash / Trouble Codes.




f.

Recheck for DTCs.

OK:

DTC B2064 is not output.




OK

NG

3.REPLACE MAIN BODY ECU
3.REPLACE MAIN BODY ECU
a.


NEXT

4.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
4.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash / Trouble Codes.




f.

Recheck for DTCs.

OK:

DTC B2064 is not output.




OK

END (MAIN BODY ECU WAS DEFECTIVE)

NG