1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55607
8.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55550
9.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
82877
10.REMOVE ECU INTEGRATION BOX RH (for LHD)
82878
11.REMOVE ECU INTEGRATION BOX LH (for RHD)
89815
12.REMOVE SEAT BELT CONTROL ECU
for LHD:
Disengage the 2 claws and remove the seat belt control ECU.
for RHD:
Disengage the 2 claws and remove the seat belt control ECU.