When a new driving support ECU assembly is installed, it receives vehicle specification information (destination, steering wheel position, 2WD or 4WD information, etc.) from the main body ECU and hybrid vehicle control ECU and memorizes the information.
DTC C1A02 is stored when the driving support ECU assembly receives the vehicle specification information from the main body ECU but cannot record it.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1A02 | Inconsistent vehicle specification information between the main body ECU and driving support ECU assembly continues for 13 second or more while the vehicle is being driven at a speed of 50 km/h (31 mph) or more. | ·
CAN communication system ·
Driving support ECU assembly |
This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus:
Body Electrical / Pre-Crash 2 / Trouble Codes.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs.
CAN communication system DTC is not output.
OK
NG
(See pagePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM)