The driving support ECU assembly uses the millimeter wave radar sensor to detect obstacles in front of the vehicle.
Based on this information, the driving support ECU assembly sends pre-crash control operation signals.
When the millimeter wave radar sensor is replaced with a new one, it acquires the country specification information from the driving support ECU assembly. Also, when the driving support ECU assembly is replaced with a new one, it receives country specification information from the main body ECU. When country specification information in the sensor, ECU and/or main body ECU do not match, DTC C1A0A is stored.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1A0A | When the power switch is on (IG), the country specification information from the driving support ECU assembly and millimeter wave radar sensor do not match for 2.4 seconds or more. | ·
Millimeter wave radar sensor ·
Driving support ECU assembly |
When the millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).
Using the GTS, enter the following menus: Powertrain / Radar Cruise / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Country# (F Radar Sens) | Millimeter wave radar sensor country signal/JPN, NA, EURO, AUS, SAFC, OTHER, TWN, CHINA, THAI, GCC, NOFIX | Actual country code | - |
Read the Data List and check the country specification information of the millimeter wave radar sensor and vehicle.
| Result | Proceed to |
|---|---|
| Country specification information for vehicle and millimeter wave radar sensor match | A |
| Country specification information for vehicle and millimeter wave radar sensor do not match | B |
A
B