Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1A40  ENG / EHV Device  


DESCRIPTION

When the driving support ECU assembly receives a hybrid control system or engine control system malfunction signal from the power management control ECU via the CAN communication system, DTC C1A40 is stored.

When DTC C1A40 is stored, hybrid control system or engine control system DTCs will also be stored.

DTC No. DTC Detection Condition Trouble Area
C1A40 While the power switch is on (IG), a hybrid control system or engine control system malfunction signal is detected for 3 seconds.
·

Hybrid control system

·

Engine control system

·

Power management control ECU

·

Driving support ECU assembly



PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL SYSTEM)
a.

Check DTCs for the hybrid control system (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

Hybrid control system DTC is not output.




OK

2.CHECK DTC OUTPUT (ENGINE CONTROL SYSTEM)

NG

2.CHECK DTC OUTPUT (ENGINE CONTROL SYSTEM)
a.

Check DTCs for the engine control system (See page Engine / Hybrid System>2ZR-FXE (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR).

OK:

Engine control system DTC is not output.




OK

3.REPLACE POWER MANAGEMENT CONTROL ECU

NG

3.REPLACE POWER MANAGEMENT CONTROL ECU
a.

Replace the power management control ECU (See page Power Source / Network>POWER DISTRIBUTION>POWER MANAGEMENT CONTROL ECU>REMOVAL).



NEXT

4.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
4.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash 2 / Trouble Codes.




f.

Recheck for DTCs.

OK:

DTC C1A40 is not output.




OK

END (POWER MANAGEMENT CONTROL ECU WAS DEFECTIVE)

NG

REPLACE DRIVING SUPPORT ECU ASSEMBLY