1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55607
8.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55550
9.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)
55480D
10.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)
Use the same procedure as for the LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL).
82877
11.REMOVE ECU INTEGRATION BOX RH (for LHD)
82877
12.REMOVE ECU INTEGRATION BOX RH (for RHD)
88150A
13.REMOVE DRIVING SUPPORT ECU ASSEMBLY (for LHD)
Disengage the claw and remove the driving support ECU assembly.
When removing the driving support ECU assembly, if the bracket for the park assist ECU is on top of the bracket for the driving support ECU assembly, remove the park assist ECU first (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU>REMOVAL).
88150A
14.REMOVE DRIVING SUPPORT ECU ASSEMBLY (for RHD)
Disengage the claw and remove the driving support ECU assembly.
When removing the driving support ECU assembly, if the bracket for the park assist ECU is on top of the bracket for the driving support ECU assembly, remove the park assist ECU first (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST ECU>REMOVAL).