Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  B2090  Driving Support System Malfunction  


DESCRIPTION

The seat belt control ECU receives crash information from the driving support ECU assembly and brake booster with master cylinder (skid control ECU) via CAN communication, and tightens the seat belts by operating the motor inside each front seat outer belt assembly.

When the driving support ECU assembly detects a malfunction in the dynamic radar cruise control system and pre-crash system, the malfunction information is sent to the seat belt control ECU, which stores this DTC.

When DTC B2090 is stored, other DTCs are also stored by the driving support ECU assembly (dynamic radar cruise control system and pre-crash system).

DTC No. DTC Detection Condition Trouble Area
B2090 While initial check is running, the power switch is on (IG) and the pre-crash system is operating, a malfunction is detected in any system of the driving support system for 1 second.
·

Driving support ECU assembly

·

Seat belt control ECU



CAUTION / NOTICE / HINT

HINT:

When clearing the DTCs, first clear the DTC output from the driving support ECU assembly (Pre-Crash 2), and then clear the DTC output from the seat belt control ECU.


PROCEDURE

1.CHECK DTC OUTPUT (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
a.

Check DTCs for the dynamic radar cruise control system (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

Dynamic radar cruise control system DTCs are not output.




OK

2.CHECK DTC OUTPUT (DRIVING SUPPORT ECU ASSEMBLY (PRE-CRASH 2))

NG

2.CHECK DTC OUTPUT (DRIVING SUPPORT ECU ASSEMBLY (PRE-CRASH 2))
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash 2 / Trouble Codes.



e.

Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).

OK:

"Pre-Crash 2" DTC is not output.




OK

3.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)

NG

3.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash / Trouble Codes.




f.

Recheck for DTCs.

OK:

DTC B2090 is not output.




OK

END

NG

REPLACE SEAT BELT CONTROL ECU