Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2013.08–2014.11
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  B2085  Communication Error from Driving Support ECU to VSC ECU  


DESCRIPTION

This DTC is stored when CAN communication between the driving support ECU assembly and brake booster with master cylinder (skid control ECU) is interrupted.

This circuit consists of the driving support ECU assembly, brake booster with master cylinder (skid control ECU) and seat belt control ECU. DTC B2085 is stored when the seat belt control ECU detects an interruption in CAN communication between the driving support ECU assembly and brake booster with master cylinder (skid control ECU).

DTC No. DTC Detection Condition Trouble Area
B2085 The brake booster with master cylinder (skid control ECU) detects an interruption in CAN communication between the driving support ECU assembly and brake booster with master cylinder (skid control ECU) for 1 second or more.
·

CAN communication system

·

Seat belt control ECU



CAUTION / NOTICE / HINT

HINT:

This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection.


PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)

b.

Check for DTCs.

OK:

CAN communication system DTC is not output.




OK

2.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)

NG

2.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash / Trouble Codes.




f.

Recheck for DTCs.

OK:

DTC B2085 is not output.




OK

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOMS SIMULATION)

NG

REPLACE SEAT BELT CONTROL ECU