1.INSTALL FRONT SEAT ASSEMBLY
Place the front seat assembly in the cabin.
Be careful not to damage the vehicle body.
Connect each connector and clamp under the seat.
Temporarily install the front seat assembly with the 4 bolts.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
Tighten the 2 bolts on the front side of the seat.
Tighten the bolts in the order indicated in the illustration.
Lift up the seat track adjusting handle and move the seat to the foremost position.
Tighten the 2 bolts on the rear side of the seat.
Tighten the bolts in the order indicated in the illustration.
72138H
2.INSTALL REAR INNER SEAT TRACK BRACKET COVER
Engage the guide.
Engage the claw to install the rear inner seat track bracket cover.
72138J
3.INSTALL REAR OUTER SEAT TRACK BRACKET COVER
Engage the 2 claws to install the rear outer seat track bracket cover.
72128A
4.INSTALL FRONT INNER SEAT TRACK BRACKET COVER
Lift up the seat track adjusting handle and move the seat to the rearmost position.
Engage the 2 claws to install the front inner seat track bracket cover.
72124
5.INSTALL FRONT OUTER SEAT TRACK BRACKET COVER
Engage the 2 claws to install the front outer seat track bracket cover.
71910A
6.INSTALL FRONT SEAT HEADREST ASSEMBLY
7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64995
8.INSTALL DECK FLOOR BOX RH
64993
9.INSTALL REAR DECK FLOOR BOX
58411A
10.INSTALL NO. 1 DECK BOARD
58412A
11.INSTALL NO. 2 DECK BOARD
58410B
12.INSTALL DECK BOARD ASSEMBLY
13.INSPECT FRONT SEAT ASSEMBLY
During the sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat installation bolts to adjust the adjuster position.
w/ Seat Heater System:
Check the seat heater operation.
Turn the power switch on (IG).
Turn the seat heater switch on.
Wait 5 minutes or more and confirm that the seat surface becomes warm.
14.INSPECT SRS WARNING LIGHT