Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat) › 2014.11–2016.05
RM2070E _58 Vehicle Interior _061944 SEAT _0301816 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT SEAT ASSEMBLY

a.

Place the front seat assembly in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.

Connect each connector and clamp under the seat.


c.

Temporarily install the front seat assembly with the 4 bolts.


d.

Lift up the seat track adjusting handle and move the seat to the rearmost position.


e.
B229808E04
0.167,2.521 0.365,2.729 0.198,0.208 10 false (1) 0.479,2.771 0.667,2.979 0.188,0.208 10 false (2)

Tighten the 2 bolts on the front side of the seat.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

HINT:

Tighten the bolts in the order indicated in the illustration.



f.

Lift up the seat track adjusting handle and move the seat to the foremost position.


g.
B229807E04
1.885,2.708 2.083,2.917 0.198,0.208 10 true (1) 1.604,2.229 1.802,2.438 0.198,0.208 10 true (2)

Tighten the 2 bolts on the rear side of the seat.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

HINT:

Tighten the bolts in the order indicated in the illustration.



Hide 72138H 2.INSTALL REAR INNER SEAT TRACK BRACKET COVER

a.

Engage the guide.


b.

Engage the claw to install the rear inner seat track bracket cover.


Hide 72138J 3.INSTALL REAR OUTER SEAT TRACK BRACKET COVER

a.

Engage the 2 claws to install the rear outer seat track bracket cover.


Hide 72128A 4.INSTALL FRONT INNER SEAT TRACK BRACKET COVER

a.

Lift up the seat track adjusting handle and move the seat to the rearmost position.


b.

Engage the 2 claws to install the front inner seat track bracket cover.


Hide 72124 5.INSTALL FRONT OUTER SEAT TRACK BRACKET COVER

a.

Engage the 2 claws to install the front outer seat track bracket cover.


Hide 71910A 6.INSTALL FRONT SEAT HEADREST ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 13.INSPECT FRONT SEAT ASSEMBLY

a.

During the sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the seat installation bolts to adjust the adjuster position.


b.

w/ Seat Heater System:

Check the seat heater operation.

i.

Turn the power switch on (IG).


ii.

Turn the seat heater switch on.


iii.

Wait 5 minutes or more and confirm that the seat surface becomes warm.